WAGNER StandardSpray Mode D'emploi page 7

StandardSpray
COATING MATERIAL
Clear varnishes, synthetic
enamels, coloured paints,
alkyd resin varnishes
Primers, radiator paints,
hammer effect enamels
Anti-rust paints, special-
effect paints
Multicolor paints, textured
paints
Assembly
For assembly, insert the spray attachment into the gun handle so that the two
arrows point at each other. Turn the gun handle 90° in the arrow direction until
it audibly engages. (Fig. 1)
To remove the spray attachment, push the catch (Fig. 1, A) beneath the trigger down and
turn the spray attachment by 90°.
For further information on setting the spray pattern and the correct spraying
technique refer to the instructions of the basic device.
Spare Parts (Fig. 2)
You cannot combine different-coloured parts of other attachments.
POS. ORDER NO.
1 2321 879
2 2314 594
3 2314 591
4 2332 577
5 2317 807
6 2314 585
7 2317 423
PROCESSING
observe manufacturer's
instructions
observe manufacturer's
instructions
observe manufacturer's
instructions
observe manufacturer's
instructions
DESIGNATION
StandardSpray spray attachment (yellow) complete
Spray jet width adjusting lever (shaping air)
Spray jet level adjusting ring (vertical/horizontal)
Union nut (yellow)
Air cap
Air screen
Nozzle (S 4.1)
COMMENTS
WallSpray spray
attachment (white)
recommended
GB
5