Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY STEP 9
E9 HANDLEBAR
19
7
18
16
20
17
11
E7 HANDLEBAR
6
14
HZ14_AG_Elite_E7_E9_Rev1_2.indd 14-15
NOTE: All hardware for this step is pre-installed.
A Remove 4 PRE-INSTALLED BOLTS (16) from the
CONSOLE (17).
B Attach the CONSOLE CABLES (7) to the
CONSOLE (17).
C Carefully tuck the CONSOLE CABLES (7) into the
CONSOLE MAST (6) before attaching the CONSOLE.
Attach CONSOLE (17) to CONSOLE MAST (6) using
4 PRE-INSTALLED BOLTS (16).
NOTE: Do not to pinch any wires while attaching the console.
D Slide the HANDLEBAR BOOT (18) halfway up
the UPPER HANDLEBAR (19). Slide the UPPER
HANDLEBAR (19) onto the LOWER HANDLEBAR (11)
making sure handlebars are joined together completely.
Secure the UPPER HANDLEBAR (19) to the LOWER
HANDLEBAR (11) using PRE-ATTACHED SET
SCREWS (20).
NOTE: Make sure upper handlebars are as far down as
possible. Handlebars can be damaged If not secured correctly.
E Repeat STEP D on other side.
ASSEMBLY COMPLETE!
ASSEMBLY STEP 10
(E9)
19
22
21
11
If you would like to use the elliptical without the
UPPER HANDLEBARS (19), you can install the
HANDLEBAR COVERS (21) instead.
NOTE: All hardware for this step is included in the
plastic bag with the HANDLEBAR COVERS.
18
A If the UPPER HANDLEBARS (19) are
already installed, remove the PRE-
20
INSTALLED SCREWS (20) and slide
off the UPPER HANDLEBARS (19) and
HANDLEBAR BOOTS (18) from the LOWER
HANDLEBARS (11).
B Remove 2 HANDLEBAR COVERS (21) and
SCREWS (22) from plastic bag.
C Place HANDLEBAR COVERS (21) over the
LOWER HANDLEBARS (11) and attach using
2 included SCREWS (22).
E9
15
6/30/14 2:07 PM
Publicité
