Horizon Fitness ELITE E7 Guide D'assemblage page 5

ASSEMBLY STEP 3
G
H
I
3 2
8
HZ14_AG_Elite_E7_E9_Rev1_2.indd 8-9
HARDWARE FOR STEP 3
PART TYPE QTY
G BOLT 4
H SPRING WASHER 4
I FLAT WASHER 4
Open HARDWARE FOR STEP 3.
A
Attach the GUIDE RAIL SET (3) to the
B
MAIN FRAME (2) using 4 BOLTS (G),
4 SPRING WASHERS (H) and 4 FLAT
WASHERS (I).
ASSEMBLY STEP 4
8
L
B
K
9
J
NOTE: Be
careful not
to pinch any
wires while
attaching the
console mast.
HARDWARE FOR STEP 4
PART TYPE
J WAVY WASHER
6
K FLAT WASHER
B SPRING WASHER
7
L BUTTON HEAD BOLT
5
Open HARDWARE FOR STEP 4.
A
2
Carefully pull the CONSOLE CABLE (5)
B
through the CONSOLE MAST (6) using
the twist tie located inside the CONSOLE
MAST (6).
Attach CONSOLE MAST (6) to MAIN
C
FRAME (2) using PRE-INSTALLED
BOLTS AND WASHERS (7).
Slide WAVY WASHER (J) over CRANK
D
(8) followed by PEDAL ARM (9) as shown.
Rest pedal arm wheel on guide rail.
Attach the PEDAL ARM (9) to the CRANK
E
(8) using 1 FLAT WASHER (K), 1 SPRING
WASHER (B) and 1 BOLT (L).
F Repeat steps D–E on the opposite side of
the elliptical.
QTY
2
2
2
2
9
6/30/14 2:07 PM