Qsens (Optional) - Hapro Luxura Mode D'emploi

Qsens (optional)

During a tanning session Qsens will gently spray the body with a ne water mist. This
results in a wonderful cooling e ect. By default Qsens is set to spray in intervals of 2
minutes.
Water
Qsens uses a special bacteria-free water. Contaminated water may cause a rash or other unpleasant skin
disorders. Therefore, never use ordinary tap water but make sure to order the special Qsens liquid containers
from your dealer.
Maintenance
Qsens is virtually maintenance-free, on the condition that pure water is used. Contaminated water may cause
blockages in the spray head and other components. Damages that are the result of the use of non-original
parts or ordinary tap water are not covered by the warranty.
Only use original Hapro parts when carrying out maintenance or repair work.
The sunbed contains electrical components that will break down in damp conditions. Make sure not to spill any
liquid on the sunbed.
Always switch o the mains voltage before carrying out any maintenance to the sunbed.
The system should be bled before commissioning the system and if any air is present in the conduit. Refer to the
section 'Initialisation' in this product description to nd out how to bleed the system.
Residual liquid from the liquid container may be discharged into the regular water drainage system. The liquid
container is made of PE and can be recycled.
Initialisation
Make sure to bleed the system before using Qsens for the rst time and when the liquid container has been
exchanged. Make sure all air and water hoses are correctly installed and that the supply hose is correctly
positioned in the liquid container before the system is bled.
Follow the instructions below to bleed the Qsens system.
Press the following keys successively:
<STOP> <STOP> <PLUS> <STOP> <MIN>
The main parameter "P1" will appear at the top of the display, and the name of the
main parameter "UNIT" will scroll across the bottom.
Use the <MIN> and <PLUS> keys to navigate to main parameter "P3". (Press
<PLUS> 2x.)
The main parameter "P3" will appear at the top of the display, and the name of the
main parameter "QSENS" will scroll across the bottom.
Press <START> 1x
ENGLISH
23