Dometic SANITATION Saneo B Instructions De Montage page 29

Saneo B, Saneo C
The layout of the touch-switch control unit (fig. m A, page 18) and of the tact-switch
control unit (fig. m B, page 18) is as follows:
Item Label
1 5-pin connector for Reed sensors cassette tank and micro-switch cassette
2
Only Saneo BW, CW
3 Jumper (only touch-switch control unit)
4
Only Saneo B, C, BS, CS, BLP, CLP
Only Saneo BW, CW
5 12 V supply
6 Fuse (10 A)
➤ Connect the toilet via the main terminal block of the vehicle to its own power
supply (fig. l, page 17 and fig. m 5, page 18). Use the corresponding cable
(fig. n, page 18):
Pos./cable colour Label
A
B
C
D
wt
rt
bl
EN
:
Float level indicator, water tank
:
Valve connection
:
Internal pump connection
Saneo B, BS, BLP, C, CS, CLP
(do not use when using a pressurised water pump)
Saneo BW, CW
Saneo B, BS, BLP, C, CS, CLP with pressurised water pump
(Australia)
Saneo BW, CW (UK)
White cable, earth (–)
Red cable, input (+)
Blue cable, output (+)
Control line for an external pump
(do not use when using a pressurised water pump)
Electrical connection
29