Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
16.
MECHANICAL ADJUSTMENT AND SETTINGS
The machine is adjusted by fabric. But there can be some adjustments done alter if there is a change
on the conditions of use.
Following there are some details to see the different adjusts group a group.
16.1. ENTRANCE BAND
TIGHTNING OF THE TRANSPORTATION BAND
The sides of the transportation band can be tenses or loosened if the canvas slipped over the
screws or they were slowing.
For that, we'll act on the tightening screws A (figure 1) situated on both sides of the machine.
We'll loosen nut B with the screw, tightening or loosening the canvas always the same way on
both sides.
Always tighten the nut B when you've finished the tense operation
Important: it's not convenient to leave the band to tight.
CENTRING THE TRANSPORTATION BAND
If the band had any tendency to move sideways over the screws, you'll have to do the centring the
following way:
Tense slowly the transportation band only on the side where it moves to until you see that its starts to
move to the opposite side.
At this moment loosen slightly at that same side, until you observe that it keeps centred.
Repeat the process if its necessary. The process of centring the band is slow and you need patience.
B
figure 1
Page 31
A
Publicité
Table des Matières
