Medisana 88941 Mode D'emploi page 19

3.1
Using with the
power supply unit
3.2
Using with
batteries
The MNV massager is intended for targeted treatment of the neck and shoulder
area. The pleasant vibrating massage has two levels of intensity. The massage
can be enhanced with heat treatment. The red light relieves tension in the neck
and shoulder muscles.
The appliance can also run on batteries so that you can use it anywhere away
from the mains.
CAUTION
Make sure that the maximum operating time of 15 minutes is
not exceeded.
1. Insert the power supply unit plug
trol unit .
2. Plug in the power supply unit.
3. Place the massager
shoulders.
4. A flexible wire frame is built into the cover of the appliance which allows
you to adjust the shape of the appliance to your neck. Bend it into the
required position.
5. Press the MASSAGE button
appliance starts working straight away at high intensity. Press the
MASSAGE button
Press the MASSAGE button
6. To switch on the heat function, the power supply unit must be connected
and the massage function switched on.
7. Press the HEAT button
light creates a gentle, pleasant heat.
8. To switch the heat function off, press the HEAT button
NOTE
The massage intensity declines when the heat function is
switched on.
Changing the batteries
Undo the zip on the back of the appliance to get into the battery compartment
. Remove the lid of the battery compartment. Insert four batteries (1.5 V, type
AA LR 6). Remember to insert the batteries as indicated in the diagram in the
battery compartment. Replace the battery compartment lid and do the zip up
again carefully.
into the connection
around the neck so that it has sufficient hold on the
, to switch on the massage function. The
twice to change to massage intensity to a lower level.
once again to switch the appliance off.
and the LED indicator lamp lights up. The red
3 Operating
on the con-
again.
13
GB