SFA SANI COMPACT Comfort Notice D'installation page 9

9 CONNECTIONS
NB: check the following before making the
various connections:
1 - Check that the threaded rods are properly
screwed into the unit, and that the
stainless steel inserts E
as shown in the figure.
2 - Offer the cut-out template
support rods.
9a CONNECTING THE DISCHARGE PIPE
1
- Connect elbow F (fitted with a length of
pipe containing a non-return valve) to the
discharge hose by means of one of the
hose clips .
H
The length of pipe is fixed to the elbow
by means of the other hose clip
2 - Fix the elbow to the outlet pipe by
means of the hose clip G
3 - Use the polystyrene chock to support the
ceramic bowl during this operation.
9b CONNECTING THE WATER SUPPLY
Connect the end of the water inlet pipe to the
connector fitted previously.
FITTING THE BOWL
1 0
Once the connections have been made,
locate the bowl on the threaded bowl support
rods.
Keep the supporting chock under the bowl.
NORM
1 1
TESTING AND
1 2
COMMISSIONING
12a COMMISSIONING
1 - Switch on the power supply. Wait
20 seconds for the appliance to initialise.
Open the water valve fully, to rinse entire
appliance through.
Activate (full flush) by pressing on the
dark grey part of the pushbutton.
Throw in a few sheets of toilet paper, then
flush again.
2 - Remove the bowl, and check that all
connections are completely watertight.
12b PROGRAMMING
SANICOMPACT
The length of your
Comfort/SANICERAMIC 4
®
according to which cycle you choose.
Eco flush (light grey button):
11 seconds and 1.8L: rinsing of the bowl for
5 seconds, the pump works for 4 seconds
(for 2 seconds, the bowl continues to fill),
then the bowl fills again for 2 seconds.
Normal flush (by default, dark grey
button):
17 seconds and 3L: The bowl is rinsed for
10 seconds, the pump works for 5 seconds
(for 3 seconds, the bowl continues to fill) then
the bowl fills again for 2 seconds.
You can lengthen the first rinse of the normal
flush to 16 seconds if the default flush is not
enough.
are positioned
C to the bowl
To re-programme:
• Press the two grey buttons at the same time
for 5 seconds.
• The motor works for 2 seconds, this means
you have entered programming mode.
• Each time you press the dark grey button
you increase the length of the normal flush
by 1 second: each time you press it will be
validated by the motor running for a short
period.
H .
• Each time you press the grey button you
decrease the length of the flush by
.
1 second: each time you press it will be
validated by the motor running for a short
period.
To exit programming mode:
• Either press both grey buttons at the same
time for 5 second.
• Or do nothing for several seconds.
The motor runs for 2 seconds, this means
that you have left programming mode.
Comment 1: the minimum length of the first
rinsing flush for the normal flush is 10
seconds (default programming) and the
maximum length is 16 seconds.
Comment 2: the eco flush cannot be
modified.
COMPLETING
1 3
THE INSTALLATION
1 - Remount the pan onto the threaded
rods.
2
- Tighten the side screws on the inside of
the stainless steel inserts until the bowl
is totally fixed in place.
3
- Finally add the screw covers.
USAGE
1 4
1 - A WC fitted with a SANICOMPACT
Comfort/SANICERAMIC 4
macerator does not require any special
maintenance.
®
flush varies
2 - WARNING:
Comfort/SANICERAMIC 4
should only be used for the
evacuating of normal human waste,
toilet paper and household WC
cleansers.
Damage may occur to the machine if
the following are disposed of via the
WC; Cotton wool, tampons, sanitary
towels, wet wipes, kitchen towels,
condoms as well as other fabric or
hard objects. Solvents, acids and
®
pump/
®
The SANICOMPACT
®
range
®
9
other chemicals can also cause
damage to the unit, and will
invalidate the warranty.
3 - WARNING: In the event that the unit is
not to be used for a prolonged time the
water supply to the bathroom is turned off.
4 - This device is not designed for
persons (including children) with
limited physical, sensory or mental
abilities, or those with minimal
experience and knowledge, unless
they are monitored and are given the
necessary instructions for using the
device, with the help of a person
responsible for their safety. Monitor
children and make sure they do not
play with the device.
CARE OF YOUR
1 5
SANICOMPACT®
COMFORT/SANICERAMIC 4®
• Normal household bleaches/WC cleansers
can be used with a SANICOMPACT
Comfort/SANICERAMIC 4
®
• To avoid the build up of limescale in the unit,
use the following procedure.
- disconnect the power supply to the unit,
- pour 3 or 4 litres of water mixed with a
strong solution of descalent/spirit of salts
into the WC pan,
- leave it to stand for 1 or 2 hours, then
re-connect the electric supply,
- flush several times to clear.
The frequency of this operation will depend on the
hardness of the water in your locality. We would
recommend this be done about twice a year.
AFTER SALES SERVICE
1 6
In the unlikely event of a failure or
malfunction, please call our after sales
service department. You will be directed to
your nearest registered service engineer.
WARNING: Always disconnect the electricity
supply before attempting any work on the
SANICOMPACT Comfort/SANICERAMIC 4
®
GUARANTEE
1 7
The SANICOMPACT Comfort/
®
SANICERAMIC 4 range is guaranteed for
®
2 years, subject to correct installation and
usage.
®
.
®