Possible Troubleshooting - EdilKamin IDROPELLBOX 15,7 Installation, Usage Et Maintenance

POSSIBLE TROUBLESHOOTING

regarding the motivation of the shutdown (see the various alarms below).
Never pull the plug during shutdown on account of malfunction.
tand then press the button 0/1.
crucible.
INDICATION OF POSSIBLE CAUSES OF MALFUNCTION AND INDICATIONS AND REMEDIES:
1) Signalling: H2O PTC_FAULT
Problem: Shuts down due to the water temperature sensor being broken or disconnected.
Actions:
- Chec connection o the sensor to the control oard.
- eri unctionalit
Problem: Shutdown for smoke extraction speed fault detection
Actions: Chec smo e e tractor unction devolution sensor connection and oard DEA E .
Chec smo e channel or dirt
eri the electrical s stem and earthing s stem.
Chec eletronic circuit oard DEA E .
3) Signalling: Stop/Flame: this trips i the thermocouple detects a smo e temperature lo er than the value set,
hich it interprets as the a sence o
Problem: Turns off due to drop in smoke temperature
lame ma
- lac o pellets
- too man pellets have su ocated the ame, chec pellet qualit
- the ma imum thermostat has intervened rare, this onl intervenes in the event o e cessive smo e
temperature DEA E
4) Signalling: Block_FI/NO Start: intervenes i a ame ails to appear ithin a ma imum o 15 minutes,
or i ignition temperature is not reached .
Problem: Turns off due to incorrect smoke temperature during ignition
Distinguish either o the ollo ing cases
Flame does NOT appear
Actions:
Chec - com ustion cham er position and cleanliness
- arrival o com ustion air in the com ustion cham er
- i the heating element is or ing DEA E
- room temperature i lo er than 3°C use a relighter and damp.
- Tr to light ith a relighter see page 34 .
Flames appear, but AF appears on the display after Ar.
Actions:
Chec onl
- i the thermocouple is or ing DEA E
- start-up temperature setting in the parameters DEA E .
5) Signalling: Black Out: not a de ect o the oiler- replace .
Problem:
Turns o due to lac o electricit
Actions: Chec electricit connection and drops in voltage.
6 ) Signalling: Fault/RC: intervenes i the thermo coupling has ailed or is disconnected .
Problem: Turns off due to thermo coupling failed or disconnected
Actions:
eri care
Chec connection o thermo coupling to oard
chec
7) Signalling: smoke °C/high.: (turns o due to e ceeding ma imum smo e temperature .
Problem: Spegnimento per superamento temperatura massima fumi.
Chec
pellet t pe, anomal in smo e e traction,
smo e channel loc ed,
incorrect installation,
gear motor dri t'
means o a cold test
this trips i the smo e e traction speed sensor detects a ault
ames
ail or an o the ollo ing reasons
the Dealer
unction in cold test DEA E .
onl the Dealer
DEA E
- 39
-