Refuel; Charging Battery Für E-Start - Zipper Maschinen ZI-BRM52EST Manuel D'utilisation

14.2.3 Refuel

Use only unleaded fuel with min. 95 octane (corresponding device fuel)
Never use 2-stroke mixture of diesel! DAMAGE OF ENGINE!
 Refuelling only outdoors!
 Before removing the filler cap, turn the engine off and let it cool machine
 Clean the fuel filler cap area
 Remove the filler cap carefully
 Fill in fuel
 Fuel tank capacity: 1 l. Fill tank only up to 1,5 cm below the rim of the
filler neck, so that the fuel has place for expansion.
 Replace and tighten the filler cap
 Wipe any fuel residues and wait until it evaporates
14.2.4 Charging battery für E-start
 Connect the charger to the power supply
(AC outlet) 230 V / 50 Hz
 Connect the charger with the battery
 Charge the battery
 Once the battery is fully charged disconnect the
battery and the charger
 Li-Ion batteries have nor memory effect. A partial
charge will not damage the battery.
LED- indicator light:
LED flashes green: Battery is charging
LED lights green: Battery is fully charged
LED lights red: Battery overload / check fuse
LED lights red: Contact costumer service
Battery status light:
Battery condition can be checked at any time by pressing the test-button
(1) beside the status lights (2).
4 x LED = fully charged
If no LED, recharge the battery
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-BRM52EST
WARNING
OPERATION
30