Midland BT NEXT Guide D'utilisation page 25

How to use a Phone
After pairing your phone to the BTNext unit you must switch to the "Phone" mode
in order to use it. Press the middle button until you hear "Phone" from the voice an-
nouncement. Now all the three main button are dedicated to the phone (see Table B)
Answering a call
When you hear the phone ring, you can answer in two different ways:
Vocally:
Simply say one word to answer the call and start talking.
Manually:
Tap the "Forward" button and start talking.
Rejecting a call
If you don't wish to answer, you can let the mobile phone ring or press the "Forward"
button for 3 seconds (you will hear one audio confirmation tone).
Making a call
There are several ways to make a call.
From the mobile keypad:
Dial the number on the mobile keypad:
Press "Send" on the mobile phone.
To redial the last number:
Press "Forward" button for 3 seconds in order to redial the last number (you will hear
one audio confirmation tone).
To make a voice call:
Briefly press "Forward" button. If your mobile phone supports voice calls, you will be
asked to speak the name of the contact you wish to call.
Priority: Calls have a high priority, which means that all other communications are
temporarily disabled when a call arrives.
Ending a call
There are several ways to end a call:
› Wait for the called person to end the call.
› Press the "Forward" button (you will hear an audio confirmation tone).
› Press "End" button on the mobile phone.
C-Radio FM mode
Mode Forward button
FM Radio Short press: seek station up
Long press: Scan recorded
24 - Midland BT Next
Using the MP3 player feature of the mobile phone
Many mobile phones are now designed to be used as stereo MP3 players. The BT-
Next device fully supports the A2DP and AVRCP protocols that enable you to listen
to stereo music and remotely control your mobile phone' s MP3 player. You can even
use the buttons on the BTNext unit to control the following play options: Play, Pause,
Forward and Backward.
Forward
Available controls:
› To play/pause music: click on the "Middle" button.
› To skip forward to the next song: press the "Forward" button.
› To skip backwards to the previous song: press the "Rear" button..
Priority: the music listening mode has the lowest priority. Therefore, it will always be
disabled when another type of communication is enabled.
Attention: It is possible to listen A2DP Stereo music only in "Phone Mode"
How to pair the BTNext to a GPS
In general is possible to pair the BTNext to all the GPS for motorbike that support
Bluetooth headset connection.
To pair the BTNext to a GPS, you must first enter the setup mode:
1. Turn off the unit
2. Press and hold down the "Middle" button about 7 sec., until the Red light is on
permanently.
3. Now press firmly (3 sec) the "Volume +" or "Volume -" button, the Blue and Red
light will flash.
4. Enable the Bluetooth device search feature on your GPS
5. After some seconds, "Midland BT NEXT" will be displayed on your GPS.
6. Follow the pairing procedure of your GPS. If a pin code is requested you must
enter "0000" (four times zero).
Middle button
Short press: On/off
Long press: Change mode
Play/Pausa Backward
Rear button
Short press: seek station up
Long press: Scan recorded