Stihl HTE 60 Notice D'emploi page 38

English
specifically designed to match the
product and meet your performance
requirements.
Never attempt to modify your machine in
any way since this may increase the risk
of personal injury. STIHL excludes all
liability for personal injury and damage
to property caused while using
unauthorized attachments.
Do not use a pressure washer to clean
your power tool. The solid jet of water
may damage parts of the power tool.
Do not spray the power tool with water.
Unsuitable extension cords can be
extremely dangerous.
Make sure that the conductor cross
section (wire gauge) of extension cords
meets the minimum requirements – see
chapter on "Starting".
Clothing and Equipment
Wear proper protective clothing and
equipment.
Clothing must be sturdy
but allow complete free-
dom of movement. Wear
snug-fitting clothing with
cut retardant inserts – an
overall and jacket combi-
nation, do not wear a
work coat.
36
Avoid clothing that could
get caught on branches
or brush or moving parts
of the machine. Do not
wear a scarf, necktie or
jewelry. Tie up and con-
fine long hair (e.g. with a
hair net, cap, hard hat,
etc.).
Wear steel-toed safety
boots with non-slip soles
and cut-retardant inserts.
WARNING
To reduce the risk of eye
injuries, wear close-fit-
ting safety glasses in
accordance with Euro-
pean Standard EN 166.
Make sure the safety
glasses are a comforta-
ble and snug fit.
Wear hearing protection, e.g. earplugs
or ear muffs.
Wear a safety hard hat with chin strap
where there is a danger of head injuries
from falling objects.
Wear heavy-duty work
gloves made of durable
material (e.g. leather).
STIHL offers a comprehensive range of
personal protective clothing and
equipment.
Transporting the Power Tool
Always switch off the motor.
Always fit the chain guard (scabbard) –
even when you carry the unit for short
distances.
Carry the power tool properly balanced
by the drive tube.
Transporting by vehicle: Properly secure
the power tool to prevent turnover and
damage.
Before Starting Work
Check that your power tool is properly
assembled and in good condition – refer
to appropriate chapters in the instruction
manual.
Correctly mounted guide bar
–
Correctly tensioned chain
–
Never attempt to modify the controls
–
or safety devices in any way.
Keep the handles dry and clean –
–
free from oil and dirt – for safe
control of the power tool.
Voltage and frequency of the machine
(see rating plate) and the voltage and
frequency of your power supply must be
the same.
HTE 60