Denon AVR-1802 Mode D'emploi page 14

ENGLISH
Speaker system connections
• Connect the speaker terminals with the speakers making sure that like
polarities are matched (< with <, > with >). Mismatching of polarities will
result in weak central sound, unclear orientation of the various instruments,
and the sense of direction of the stereo being impaired.
• When making connections, take care that none of the individual conductors
of the speaker cord come in contact with adjacent terminals, with other
speaker cord conductors, or with the rear panel.
NOTE:
NEVER touch the speaker terminals when the power is on.
Doing so could result in electric shocks.
1. Loosen by turning
counterclockwise.
Connection jack for subwoofer with built-in
amplifier (super woofer), etc.
To achieve Dolby Digital (AC-3) playback
effect, use a unit that can sufficiently
reproduce frequencies of under 80 Hz.
14
2. Insert the cord.
FRONT SPEAKER SYSTEMS
System B
( L ) ( R )
SIGNAL
PHONO
CDR /
GND
TAPE
CDR /
ANTENNA TERMINALS
TAPE
CD MONITOR
LOOP
AM
ANT.
DVD / DVD /
VDP VDP
FM
TV / TV /
COAX. COAX.
DBS DBS
75
VCR
VCR-1
-1
VCR
VCR-2
FR FL OPT-1
-2
VCR
SW C OPT-2 VCR-1
-1
VCR
OPT-2 VCR-2
SR SL
-2
EXT. IN AUDIO DIGITAL VIDEO
Speaker Impedance
• When speaker systems A and B are use separately, speakers with an
impedance of 6 to 16 Ω/ohms can be connected for use as front speakers.
• Be careful when using two pairs of front speakers (A + B) at the same time,
since use of speakers with an impedance of 12 to 16 Ω/ohms.
• Speakers with an impedance of 6 to 16 Ω/ohms can be connected for use
as center and surround speakers.
• The protector circuit may be activated if the set is played for long periods of
time at high volumes when speakers with an impedance lower than the
specified impedance are connected.
Connecting the speaker cords
3. Tighten by turning
clockwise.
FRONT SPEAKER SYSTEMS
System A
( L ) ( R )
DVD/ TV/ VCR-1 VCR-2 VCR-1
VDP DBS
S-VIDEO
FRONT
CENTER
SUB
WOOFER
PREOUT
SPEAKER SYSTEMS
FRONT
SPEAKER IMPEDANCE
FRONT A OR B / 6 16
A + B / 12 16
( L ) ( R )
SURROUND SPEAKER SYSTEMS
Connecting banana plugs
banana plug
Turn clockwise to tighten, then insert the
banana plug.
CENTER SPEAKER SYSTEM
VCR-2 MONITOR
AC OUTLETS
CENTER SURROUND AC 120V 60Hz
SWITCHED
TOTAL 120W(1A.)MAX.
CENTER / 6 16
SURROUND / 6 16
• Precautions when connecting speakers
If a speaker is placed near a TV or video monitor, the
colors on the screen may be disturbed by the
speaker's magnetism. If this should happen, move
the speaker away to a position where it does not
have this effect.