Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
2. Place the speaker
Once the speaker is connected, ensure that the tightening hooks are placed so they don't stop the
speaker from entering into its allocated slot. Insert the speaker into the partition in a manner so
the edge is at the level with the wall/ceiling. Beware not to trap the cables during the installation.
3. Attach the speaker
Then, secure the tightening hooks to fasten the speaker with a cross-head screwdriver.
Take care of not damaging the membrane of the speaker during installation.
Finally, install the magnetic grill on the front of the speaker. The speaker is ready for use. To remove
the grill, use the dismounting tool that is supplied.
The levels of the tweeter and the base of IWT7 can be adjusted (0 and -3 dB) as needed.
17
Publicité
Table des Matières
