Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
INSTALLATION
The speakers of the SECRET range are fairly easy to install. To ensure an optimal installation, please
follow these steps carefully.
1. Connect the cable
First, ensure you route the cables through the wall/ceiling in order to connect your SECRET speakers
to the amplifier. Leave some spare cables to ease connecting them to the terminals on the back of
the speaker. The maximum cable diameter accepted by the terminals is 4.5mm.
Use high-quality cables: the length of the cables needed for this type of installation is important. It
is therefore necessary to utilize cables that influence the dynamics and the signal to the speakers
the least possible.
Strip the cable, and then connect it to the spring terminal. Ensure that the speaker connexion
polarity is correct: the cable of the positive terminal on the amplifier must be connected to the red
terminal, the cable of the negative terminal must be connected to the black terminal.
For ICT7+ : make sure to connect both terminal blocks, one for the left signal, the other for the
right signal.
16
Publicité
Table des Matières
