Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CAUTION
If any visible deterioration of a system component is apparent
(cracking, discoloration, tears etc.), the component should be
discarded and replaced.
Daily/After each use:
• Disassemble the mask components according to the disassembly
instructions.
• Handwash the separated mask components (excluding headgear and
soft sleeves).
• To optimize the mask seal, facial oils should be removed from the
cushion after use.
• Use a soft bristle brush to clean the vent.
• Inspect each component and, if required, repeat washing until visually
clean.
• Rinse all components well with drinking quality water and allow to air
dry out of direct sunlight.
• When all components are dry, reassemble according to the
reassembly instructions.
Weekly:
• Handwash the headgear and soft sleeves.
Reprocessing the mask between patients
Only Sleep Lab Mask (SLM) variants of the mask are intended for
multi-patient re-use. When using between patients, these masks must be
reprocessed according to cleaning and disinfection instructions available
on ResMed.com/downloads/masks.
English
5
Publicité
Table des Matières
