Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Using your mask
When using your mask with ResMed CPAP or bilevel devices that have
mask setting options, refer to the Technical specifications section in this
user guide for mask selection options.
For a full list of compatible devices for this mask, see the Mask/Device
Compatibility List on www.resmed.com on the Products page under
Service & Support. If you do not have internet access, please contact
your ResMed representative.
Use a standard conical connector if pressure readings and/or
supplemental oxygen are required.
Fitting
1. Remove the elbow from the mask by pressing the side buttons and
pulling the elbow away.
2. With both lower headgear straps released, hold the mask against your
face and pull the headgear over your head. Ensure that the label on
the back of the headgear faces outwards when the headgear is put
on.
3. Undo the fastening tabs on the upper headgear straps. Pull the straps
evenly until the mask is stable and positioned as shown in the
illustrations. Reattach the fastening tabs.
4. Bring the lower straps below your ears and loop the headgear into the
lower hooks on the frame.
5. Undo the fastening tabs on the lower headgear straps. Pull the straps
evenly until the mask sits firmly on the chin and reattach the fastening
tabs.
6. Connect the air tubing from your device to the elbow. Attach the
elbow to the mask by pressing the side buttons and pushing the
elbow into the mask. Turn on your device so that it is blowing air.
7. Undo the fastening tabs on the upper headgear straps. Readjust the
straps evenly only enough that a seal is achieved and reattach the
fastening tabs. Overtightening may cause leaks.
8. Your mask and headgear should be positioned as shown.
Removing your mask
1. Disconnect one or both of the lower headgear straps from the hook.
2. Pull the mask away from your face and back over your head.
English
3
Publicité
Table des Matières
