Setup
Before using your monitor, check that the following items are
included in your carton:
• LCD display
• Media engine
• Power cord
• System connecting cable (2 m)
• DVI-HD15 (analog RGB) video signal cable
• Audio cord (stereo miniplug)
• USB cable
• Macintosh adapter
• Windows Monitor Information/Windows Utility/Macintosh
Utility Disk
• Warranty card
• Notes for Macintosh users
• This instruction manual
Step 1: Connect the media engine
to your computer
Turn off the media engine and computer before connecting.
When connecting the monitor to a computer equipped with a DVI
(digital RGB) output connector that complies with DVI Rev.1.0,
use a DVI-DVI (digital RGB) video signal cable (not supplied).
Note
Do not touch the pins of the video signal cable connector as this might
bend the pins.
x
Connecting to an IBM PC/AT or compatible
computer
to video output
IBM PC/AT or
compatible computer
to INPUT2 connector
DVI-HD15 (analog RGB) video
signal cable (supplied)
x
Connecting to a Macintosh
Use the supplied Macintosh adapter.
Macintosh adapter
(supplied)*
to video output
Macintosh
* Refer to the supplied "Notes for Macintosh users" for further details.
Step 2: Check the digital/analog
select switch
Before turning on the monitor or the computer, be sure to check
the switch setting. When connecting the DVI-I input connector on
the monitor to a computer equipped with an HD15 (analog RGB)
output connector using the DVI-HD15 (analog RGB) video signal
cable (supplied), set the switch to ANALOG.
When connecting it to a computer equipped with a DVI (digital
RGB) output connector using a DVI-DVI (digital RGB) video
signal cable (not supplied), set the switch to DIGITAL.
The switch is set to ANALOG as the default setting.
Note
Before turning on the monitor or the computer, be sure to check the switch
setting.
to INPUT2 connector
DVI-HD15 (analog
RGB) video signal cable
(supplied)
ANALOG
DIGITAL
(continued)
7
GB