Using The Stereo Speakers; Adjusting The Volume; Selecting The Input Signal - Sony SDM-N80 Mode D'emploi

Using the stereo speakers

You can listen to music, sound, and other audio files using the
stereo speaker of your monitor.

Adjusting the volume

Volume adjustments are made using a separate VOLUME menu,
different from the main menu (page 12).
1 Light up the characters and icons to indicate the
functions of the keys.
Touch any one of the MENU, M(+)/m(–), 8 (brightness), 6
(contrast), or INPUT keys to light up the characters and icons
indicating the functions of the keys.
2 Touch the 2 +/– keys.
The VOLUME menu appears on the screen.
3 Touch the 2 +/– keys to adjust the volume.
The menu automatically disappears after about 3 seconds.
Using the headphones jack
You can listen to the audio signals from your computer or other
audio equipment using headphones. Connect your headphones to
the headphones jack. The speakers turn off when headphones are
connected to the headphones jack. Adjust the volume of the
headphones using the VOLUME menu.
Notes
• You cannot adjust the volume when displaying the main menu on the
screen.
• When your monitor is in low power consumption mode or power
saving mode, no sound comes from the speakers or the headphones.
10
VOL UME
4 0

Selecting the input signal

You can connect two computers to this monitor using the INPUT1
and INPUT2 connectors. To select one of the two computers, use
the INPUT key.
1 Light up the characters and icons to indicate the
functions of the keys.
Touch any one of the MENU, M(+)/m(–), 8 (brightness), 6
(contrast), or INPUT keys to light up the characters and icons
indicating the functions of the keys.
2 Touch the INPUT key.
The input signal and corresponding input indicator change
each time you touch this key.
• 1: Input via the HD15 (analog RGB) input connector
• 2: Input via the DVI-I (digital/analog RGB) input
connector
Notes
• You cannot select the input signal when displaying the main menu on
the screen.
• For USB upstream input and audio input, you can choose whether or
not to allow them to be switched using the INPUT key. To set the USB
upstream input, use the (USB SELECT) menu (page 17); to set
the audio input, use the (AUDIO SELECT) menu (page 18). Both
of them are set to be switched with the INPUT key in the default setting.
2