Addressing Via Dmx-Rdm; Rdm Parameter For Underwater Led Driver/Dmx/02; Rdm Parameters For Led Spotlights - Oase 50720 Notice D'emploi

- GB -
5.2

Addressing via DMX-RDM

RDM (Remote Device Management) is a new, open and bi-directional protocol standard for DMX-controlled
devices. The permanently transmitted DMX data flow briefly pauses (several milliseconds), and an RDM data
package (message) is sent directly to a subscriber. The subscriber evaluates the information in the data pac-
kage and sends an answer (semi-duplex) on the same line. Targeted polling to a subscriber via its UID (Uni-
que ID) prevents several subscribers from answering simultaneously.
The protocol makes it possible to receive status information about a unit or to change configurations on a unit.
Changing the configuration means, e.g. changing the DMX address. The prerequisite for this function is a
RDM-compatible controller. Read the corresponding operating instructions
Individual or shared control of the unit outputs is possible. Different operating modes are possible. The opera-
ting mode can only be configured by means of the Personality ID via RDM.
5.2.1

RDM parameter for Underwater LED Driver/DMX/02

General parameters
STATUS_MESSAGES
SUPPORTED_PARAMETERS
PARAMETER_DESCRIPTION
DEVICE_INFO
DEVICE_MODEL_DESCRIPTION
MANUFACTURER_LABEL
DEVICE_LABEL
SOFTWARE_VERSION_LABEL
DMX_START_ADDRESS
SENSOR_DEFINITION
SENSOR_VALUE
IDENTIFY_DEVICE
DEVICE_HOURS
RESET_DEVICE
PERSONALITY_ID
5.2.2

RDM parameters for LED spotlights

General parameters
STATUS_MESSAGES
SUPPORTED_PARAMETERS
PARAMETER_DESCRIPTION
DEVICE_INFO
DEVICE_MODEL_DESCRIPTION
MANUFACTURER_LABEL
DEVICE_LABEL
SOFTWARE_VERSION_LABEL
DMX_START_ADDRESS
SENSOR_DEFINITION
SENSOR_VALUE
IDENTIFY_DEVICE
DEVICE_HOURS
LAMP_HOURS
22
GET SET Description
CMD CMD
• Used to manage status messages
• Overview of all RDM parameters
• Description of all parameters
• Brief overview of the most important features
• Type designation
• Manufacturer's designation
• • Labelling field
• Firmware version number
• • Only relevant and editable for the subdevice
• Sensor information
• Value of sensor 1: Current operating voltage
• • 0 = Normal mode
1 = LEDs light up in quick succession in the order: Red (R), green (G), blue (B)
• Current operating hours
• Executes a reset.
1 = warm start
• •
1 = RGB (Red-Green-Blue)
2 = RGBW (Red-Green-Blue-White)
3 = RGB stroboscope
4 = RGBW stroboscope
GET SET Description
CMD CMD
• Used to manage status messages
• Overview of all RDM parameters
• Description of all parameters
• Brief overview of the most important features
• Type designation
• Manufacturer's designation
• • Labelling field
• Firmware version number
• •
Only relevant and editable for the subdevice
•
Sensor information
•
Value of sensor 1: Current operating temperature
• •
0 = Normal mode
1 = LEDs light up in quick succession in the order. Red (R), green (G), blue (B)
•
Current operating hours
•
Current operating hours of the LEDs in operation