FUST Primotecq GS 434 Mode D'emploi page 19

CARE AND MAINTENANCE
Cleaning the filters
1. Rotate the microfilter counter-clockwise (in the direction of the
arrow "0") and extract it (E).
2. Remove the wide-mesh filter (F).
3. Remove the fine-mesh filter (G).
4. Clean all filters under running water, paying attention not to bend
the fine-mesh filter.
Check that no impurities are left inside the dishwasher!
5. To reassemble:
insert the wide-mesh filter into the microfilter so it clicks into
place. Insert the fine-mesh filter.
The filter must be fitted under both tabs (H).
Insert the wide-mesh filter / microfilter unit and turn clockwise
(in the direction of the arrow "1"), until the dashed lines on the
microfilter and fine-mesh filter are aligned.
The filter unit must be correctly assembled to ensure good
wash results!
E
F
G
H
19