Moving Your Massage Chair After It Has Been Unpacked - Human Touch ht 1650 Mode D'emploi Et D'entretien

Moving your massage chair after it has been unpacked:

DO NOT LIFT HERE
WARNING:
This product is equipped with a thermal resetting protection device. This is an added
safety feature to protect you and this product from overheating. If the product should suddenly stop
and will not start, turn the main power switch, located on the back of the product, off and do not
operate the product for at least 30 minutes. Failure to turn the product off may result in the product
starting unexpectedly when the device cools.
Your massage chair is a precision instrument that can be damaged if dropped.
Use at least two people to move it.
1. Fully retract the foot and calf massager.
Make sure the area behind/underneath the footrest is clear of any
obstructions before retracting the footrest.
NEVER pick up the chair by grasping the foot and calf massager.
2. Store the remote control in the side pocket.
3. Grasp the chair at floor level, beneath the side arms.
Your Human Touch massage chair has two fuses:
one for the chair and one for the convenience outlet.
To replace a fuse:
1. Turn the Power switch to OFF and unplug the chair from the wall outlet.
2. Turn the fuse holder (located on the power panel) approximately 1/8 turn
counter-clockwise. The fuse holder pops out.
3. Replace the fuse with a new fuse of the same value, then reinsert the fuse
holder into the power panel.
4. Turn the fuse holder 1/8 turn clockwise to secure it.
5. Plug the chair back into the wall outlet and turn it on.
25