Human Touch ht 1650 Mode D'emploi Et D'entretien page 8

get
part II
www.humantouch.com
ready
Install the Fine Floor Protector
Notched end of Floor Protector slides under foot
and calf massager (textured side up); hook-and-loop
fasteners attach to top side of the chair cross-bar.
1. Deploy the foot and calf massager
Press the legs-up button on the remote
control to fully deploy the foot and calf
massager. Pull up on the footrest release
handle (located on the right-hand side of the
footrest), then rotate the footrest away from
the chair until there is enough room to reach
underneath the front of the chair.
2. Place the Fine Floor Protector
For your safety, before installing the
Floor Protector, be sure to turn off the
chair at the main power switch and
unplug the power cord.
Lift the foot and calf massager wheels a few
inches off of the floor. With the hook-and-
loop fastener strip facing down, slide the
Floor Protector into place as shown.
8