VOLTCRAFT CHARGE MANAGER 2015 Notice D'emploi page 32

ALV (ALIVE) means that the battery will be charged and discharged, then recharged and discharged
again and finally recharged. The ALIVE programme is used for activating new batteries and such which
have been stored over a longer period of time.
CHA = Charge only once
DIS = discharge only once
CHK = Discharge - charge
CYC (CYCLE) = charge - discharge - charge
ALV = charge - discharge - charge - discharge - charge
Now you have 5 seconds to select the programme. After every time you press the key to change the
charge programme, you have another 5 seconds. Only after these 5 seconds are the settings accepted
and the programme is activated.
But you can also press the „OK" key to confirm.
Without any input, the CHARGE programme will start.
If a programme was already started in slot 1, the following is displayed
CM2015
====================
SET PROGRAM S1<>
- ADJ SAME AS S1
this means that this battery without input is processed with the same programme as the battery in slot 1.
If you therefore want to charge several batteries with the same programme, first insert a battery in slot 1
and select the desired programme. Then insert all remaining batteries; they are then charged with the
same programme without pressing any key.
The CHA, CYC and ALV programmes start the charging, whereas the DIS and CHK programmes start
the discharging.
All available data of the battery is displayed. With the two SELECT keys (UP and DOWN) the battery
data can be displayed from all slots where batteries were inserted.
If all data of the slots where there are batteries were displayed, the overview is again displayed when
pressing the key.
When displaying the individual battery data, the overall view is again displayed when pressing the „OK"
key.
32