Deleting All Scenes And Sequences Of Scenes; Remote Control With The Lc-3; Specifications - IMG STAGELINE LED-32C Mode D'emploi

4) After deleting, switch off the programming
mode. For this purpose keep button PROGRAM
REC pressed for approx. 3 seconds until its LED
stops flashing.
5.4 Deleting all scenes
and sequences of scenes
All memorized scenes and all programmed se-
quences of scenes can easily be deleted at the
same time:
1) Switch off the control panel with the POWER
switch (23).
2) Keep the buttons PROGRAM REC (2) and
DEL/CLEAR (5) pressed and switch on the unit
again.
3) When all LEDs of the control panel flash,
release the buttons pressed. The display (3)
shows the version of the firmware and then
for the selected memory bank 1. The
deleting procedure is terminated.

5.5 Remote control with the LC-3

Via the remote control LC-3 available as an acces-
sory various functions may be controlled.
1) Connect the remote control to the jack
REMOTE CONTROL (19). The LED of button
STAND BY (24) flashes. This shows that the
remote control is not activated.
2) To activate the remote control
— either keep button BLACK OUT (15) of the
control panel pressed until its LED starts
flashing
— or keep button STAND BY of the remote con-
trol pressed until its LED stops flashing.
Thus, all buttons except button BLACK OUT at
the control panel are locked. The control can
now only be made with remote control LC-3.
3) The LEDs of the spotlights can be switched on
and off with button STAND BY (24). With the
LEDs switched off, the LED next to button
STAND BY lights up as a check.
All rights reserved by MONACOR
be reproduced in any form or by any means for any commercial use.
® INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may
4) Select the operating mode with button MODE
(26):
— stroboscope
(the LED of the button does not light up)
For the stroboscope function keep button
FUNCTION (25) pressed.
— music-controlled run of a sequence of
scenes (the LED of the button lights up)
Select the desired sequence of scenes with
button FUNCTION.
— manual run of a sequence of scenes
(the LED of the button flashes)
Advance the sequence of scenes with button
FUNCTION. To select another sequence of
scenes, first switch to the music-controlled
run.
5) To activate the control panel
— either keep button BLACK OUT of the control
panel pressed until its LED stops flashing
— or keep button STAND BY of the remote con-
trol pressed for approx. 3 seconds so that its
LED starts flashing after releasing the button.

6 Specifications

DMX addresses reserved: . . 1 – 32
Number of the units or groups
of units to be controlled: . . . 8
Scenes to be memorized: . . 32
Sequences of scenes
to be memorized: . . . . . . . . . 8 with 32 scenes
Power supply: . . . . . . . . . . . 9 V / 300 mA via
Ambient temperature: . . . . . 0 – 40 °C
Dimensions: . . . . . . . . . . . . . 280 × 170 × 80 mm
Weight: . . . . . . . . . . . . . . . . 1.5 kg
Subject to technical modification.
each
supplied PSU
connected to
230 V~ / 50 Hz
GB
17