Setting The Flush Duration (S3) - DURAVIT ME by Starck 28093100 Série Notice D'utilisation

5.2

Setting the flush duration (S3)

Refer to page 2 for a diagram showing the signal sequence.
> Hold the magnetic key in front of the right-hand sensor.
Within approximately three seconds, several short signals will
sound. Then, seven long signals will sound. Between the sixth and
seventh signal tone, a longer, six-second (approx.) pause will occur.
> Remove the magnetic key.
Two short signal tones will sound, and then service programme S3
will be selected.
52
3 s 7x
2x
S3