Installation; Connection Cable - AEG HC451220EB Notice D'utilisation

There is no signal when
you touch the panel sen-
sor fields.
If you tried the above solutions and can-
not repair the problem, speak to your
dealer or the Customer Care Depart-
ment. Give the data from the rating
plate, three-digit-letter code for the
glass ceramic (it is in the corner of the
cooking surface) and an error message
that comes on.

8. INSTALLATION

WARNING!
Refer to the Safety chapters.
Before the installation
Before the installation of the appliance,
record the information below from the
rating plate. The rating plate is on the
bottom of the appliance casing.
• Model ...........................
• PNC .............................
• Serial number ....................
8.1 Built-in appliances
• Only use the built-in appliances after
you assemble the appliance into cor-
rect built-in units and work surfaces
that align to the standards.

8.2 Connection cable

• The appliance is supplied with the
connection cable.
Problem Possible cause and remedy
The signals are deactivated.
Activate the signals (see OffSound Control ).
If you operated the appliance incorrect-
ly, the servicing by a customer service
technician or dealer will not be free of
charge, even during the warranty period.
The instructions about the customer
service and conditions of guarantee are
in the guarantee booklet.
• Replace the damaged mains cable
with a special cable (type H05BB-F
Tmax 90°C; or higher). Speak to your
local Service Centre.
8.3 To attach the seal.
• Clean the worktop in the area of the
cut out section.
• Bond the seal stripe supplied on the
lower edge of the appliance along the
outer edge of the glass ceramic. Do
not extend it. Let stay the cut ends in
the middle of one side. When, you cut
it to length (add some mm), push the
two ends together.
If, you use the accessory frame C-
FRAME, first read the instruction sup-
plied with the frame before you install
the appliance.
ENGLISH
31