SwissPhone Analog Pager Mode D'emploi page 28

To turn scanning ON/OFF press the SELECT (1) button until the scan icon begins to
flash, then press the OK (2) button to switch scanning on/off. Confirm your selection
by pressing SELECT (1). Please note that there is an increased risk of missing calls
during activated scanning mode. Single channel pagers are not available with scanning.
Volume – To change the volume press the SELECT (1) button until the volume icon
begins to blink, then press the OK (2) button several times to change the volume level.
When the desired volume level is reached, confirm the selection with SELECT (1).
ll of the Icons above can be placed in the order of your choice through programming
by your dealer. You may prefer i. e. the volume icon to be the first selection in the menu.
dditional functions:
Note: Usually these functions are in the secondary menu, which may be accessed by holding
the SELECT (1) button for approximately two seconds.
• Profiles/Channels
Press SELECT (1) and cycle through the icons until the active profile is blinking. Press OK (2)
until the desired profile is flashing and confirm the selection by pressing SELECT (1).
30