Operation Of The - SwissPhone Analog Pager Mode D'emploi

4 Operation of the Pager
The Swissphone programming software allows users to divide icons between two menus:
the primary menu and the secondary menu. To access the secondary menu press and
hold the left SELECT (1) button for approximately two seconds. Previously hidden icons
appear.
Press the SELECT (1) button to navigate through the icons and press the right OK (2) button
to confirm the selection.
Main icons:
Loud alert – Pager vibrates, beeps, and plays incoming messages
Mini alert – Pager vibrates and plays incoming messages. For some configurations the
pager will also beep in addition to vibrating and playing the incoming message.
Vibrate – Pager only vibrates
Monitor – Pager will monitor the frequency specified in the active profile
Scanning on/off – Pager will scan all channels that have been programmed on the scan
list.
29