Installing The Front I/O Connectors; Installation Des Connecteurs E/S Avant • Installation Der Vorderen I/O -Anschlüsse; Instalación De Los Conectores De E/S Frontales • Установка Передних Разъемов Ввода-Вывода; Instalar Os Conectores De E/S Dianteiros - Corsair CRYSTAL Série Manuel D'installation

CRYSTAL SERIES
®

Installing the Front I/O Connectors

Installation des connecteurs E/S avant
Instalación de los conectores de E/S frontales

Instalar os conectores de E/S dianteiros

USB 3.0
HD AUDIO
17
280X
Installation der vorderen I/O-Anschlüsse
n
Установка передних разъемов ввода-вывода
n
POWER SW POWER LED –
RESET SW POWER LED +

Using Lighting Node Pro (CRYSTAL 280X RGB only)

• Turn your system off prior to installing your Lighting Node PRO.
• Plug the mini USB cable into the back of the Lighting Node PRO then plug the 9-pin
end into an available internal USB 2.0 header in your system.
• Connection Notes
> The Fan LED wiring must be connected to the fan hub in the order you want the
lighting effects to be displayed.
> Fans must start at "1" and continue in series. 1 > 2 > 3 > 4 > 5 > 6
> Any fan not connected in series will break communication and the RGB LED lighting
function will not work.
• Mount the fan(s) to the location of your choice in the chassis.
• Find a location for the fan hub that allows connection for all of the fans RGB LED cables
installed in your system to reach.
> The fan controller will also need to be plugged into the fan hub for control of the RGB
LED lighting.
• Mount the fan hub with the provided mounting strips.
18