Radio Reception; Usb Device Playback - Sony RSX-GS9 Mode D'emploi

Radio reception

Stations cannot be received.
The sound is hampered by noises.
 The connection is not correct.
 Check the connection of the car antenna
(aerial).
 If the auto antenna (aerial) will not extend,
check the connection of the power antenna
(aerial) control lead.
Preset tuning is not possible.
 The broadcast signal is too weak.
RDS
The SEEK starts after a few seconds of listening.
 The station is non-TP or has weak signal.
 Deactivate TA (page 12).
No traffic announcements.
 Activate TA (page 12).
 The station does not broadcast any traffic
announcements despite being TP.
 Tune in another station.
Program service name flashes.
 There is no alternative frequency for the current
station.
 Press / while the program service
name is flashing. [PI Seek] appears and the unit
starts searching for another frequency with the
same PI (program identification) data.

USB device playback

You cannot play items via a USB hub.
 This unit cannot recognize USB devices via a USB
hub.
A USB device takes longer to play.
 The USB device contains many files or a
complicated file structure.
The sound is intermittent.
 The sound may be intermittent at a high-bit-rate.
 DRM (Digital Rights Management) files may not
be playable in some cases.
Audio file cannot be played.
 USB device formatted with file systems other
than FAT16, FAT32 or exFAT are unsupported.*
* This unit supports FAT16, FAT32 and exFAT, but some
USB device may not support all of these FAT. For
details, refer to the operating instruction of each USB
device or contact the manufacturer.
You cannot skip to the next or previous track.
 While [*] is displayed after connecting the USB
device, the unit is busy with reading the file
structure of the device. Wait until reading is
complete.
The sampling frequency and bit depth are not
displayed, or unmatched sampling frequency
and bit depth are displayed.
 Check that the contents on the USB device
contain the information on the sampling
frequency and bit depth.
 Wait for a while, then press DSPL again. Reading
the information may take some time.
 When an iPod/iPhone is connected to USB1 or
USB2, the sampling frequency and bit depth are
not displayed.
Certain characters of the track name are not
displayed.
 Unsupported characters are used in the track
name.
USB DAC playback
No sound.
 Check that the High-Resolution USB Audio
supported device and the unit are properly
connected.
 Check that the settings of the High-Resolution
USB Audio supported device are properly made.
The sampling frequency and bit depth are not
displayed, or unmatched sampling frequency
and bit depth are displayed.
 Check that the settings of the High-Resolution
USB Audio supported device and the audio
playback software or application are properly
made.
 Wait for a while, then press DSPL again. Reading
the information may take some time.
 Depending on the audio playback software or
application, the bit depth appears on the display
may differ from the actual bit depth of the audio
file.
The track name is not displayed.
 During USB DAC playback, track names are not
displayed.
25
GB