Making The Wheelchair Smaller - Life & Mobility Canto Nxt Mode D'emploi

Settings and adjustments
Fixing the ankle hinge
n Set the ankle angle to the desired
position.
n Drill a hole in the hinge.
n Fix the ankle hinge in place by means of
a fixing pin.
ø 3 mm
2 3
Adjusting the push-handle
n Loosen the butterfly knob one turn.
n Adjust the handle to the required height.
n Retighten the butterfly knob.
Anti-tipping supports
The anti-tipping supports can be adjusted
using the lever (A). The recommended height
is 3 cm from the floor.
Please note:
• Make sure that the pin clicks properly
into the opening.
• Inform the user if the anti-tip support
is folded away.
Tip:
• The sliding sleeve can be used to
mark a standard position.
EN22
1
B
A

Making the wheelchair smaller

Removing the seat (see fig. 1)
n Pull up the back of the seat.
n Lift the seat out of the frame.
Remove the backrest from the backrest frame
(see fig. 2)
n Lift the left and right knobs of the top
fig. 1
fittings at the same time.
n Rotate the backrest forward so that
the U profile releases from the backrest
attachment points.
n Release the knobs of the top fittings.
n Lift out the backrest.
fig. 2
Removing the legrests (see fig. 3)
fig. 3
1. Remove the leg rests from the top.
Side equipped with armrest (see fig. 4)
n Loosen the star knob at the bottom of the
sides.
n Lift the entire side upwards out of the seat
frame.
Removing the headrest (see fig. 5)*
n Loosen the star knob.
n Remove the headrest from the wheelchair.
Backrest tubes (see fig. 6)
n Loosen the socket screws in the backrest
hinge points.
n Move the backrest frame towards the seat
frame.
fig. 4
n Retighten the socket screws.
fig. 5 fig. 6
* If applicable
EN23