Life & Mobility Canto Nxt Mode D'emploi page 26

Settings and adjustments
Push wheelchair + Snellius seat element
Required seat height Tyre size Position
50 cm* 6" x 12,5" A1 / T1-A
55 cm 6" x 12,5" A1 / T2-B
55 cm 8" x 12,5" A2 / T1-B
Push wheelchair + Kelvin seat element
Required Tyre size Position
seat height
55 cm 200 x 50 x 12,5" A1 / T1-B
60 cm 200 x 50 x 12,5" A1 / T2-B
Manual wheelchair
Required seat height Tyre size Position
42 cm* 20" x 6" A1 / T1-A
44,5 cm 20" x 6" A1 / T2-A
47 cm 22" x 6" A1 / T2-B
22" x 8" A1 / T1-B
49,5 cm 22" x 6" A2 / T2-C
22" x 8" A2 / T2-A
52 cm 24" x 6" A2 / T3-A
24" x 8" A2 / T2-B
54,5 cm 24" x 6" A3 / T3-B
24" x 8" A3 / T2-C
57 cm 26" x 8" A3 / T3-A
* At a seat height of 42 cm, adjusting the wheelchair to a
neutral seat angle is realised by placing the gas springs
in the upper frame hole, see also page 12.
EN18
T2-A T2-B T2-C
T3-A T3-B
A1
A2
A3
Manual wheelchair
A
Left-hand push-handle (red sticker)
Settings and adjustments
Backrest angle (one adjustment)
n Loosen the socket screws (A) in the
backrest hinge points.
n Set the backrest to the required angle.
n Then retighten the socket screws.
N.B.: make sure the left and the right
push bars are at the same angle with the
aid of the graduation mark.
Backrest angle (continuously adjustable)
The backrest angle can be adjusted using the
central gas spring and the operating lever on
the left-hand push-handle.
n Squeeze the left-hand operating lever to
disconnect the gas spring.
n Adjust the backrest to the desired angle.
n Release the lever.
EN19