Steba VG 350 Mode D'emploi page 11

∙ The appliance must not be operated using a timer or a separate
remote system!
∙ Put the silicon cover on the thermostat when the device is not
in use.
∙ Never immerse the thermostat element or the power cord
into water!
∙ Only use the device for food preparation
∙ Never use the device after a malfunction, e.g. when it was fal-
len down or was damaged in any way.
∙ If the supply cord is damaged, it must be replaced by the ma-
nufacturer, its service agent or similarly qualified persons in or-
der to avoid a hazard.
∙ Device gets hot. Only transport after it cooled down.
∙ If the appliance is used as a table top, it must be placed on a even,
stable and heat resisting surface (e.g. Not on painted furniture)
and keep away (min 70cm) of burnable materials (e.g. curtains)
∙ Before the first use: Clean all parts and dry them afterwards. To
eliminate the smell of the new item, heat it up for ca. 15min.
The device can smoke a little bit at the beginning.
∙ Attention! Housing get hot, Risk of burns! Use grill
gloves to open the lid. Don´t place the device on a sen-
sitive surface (e.g. painted furniture) and keep distance
of at least 70 cm to burnable materials (e.g. curtains).
∙ The appliance should be supplied through a residual current
device (RCD) having a rated residual operating current not ex-
ceeding 30mA.
∙ The connector shall be removed before the appliance is cleaned
and that the appliance inlet must be dried before the appliance
is used again.
∙ In order to avoid overheating, this appliance shall not be
covered by any solid or flexible material such as an alumi-
num tray, aluminum foil or trays made of other heat resistant
material. The use of such items or materials on the grille would
impair the safety of your product and could lead to serious da-
mage.
11