Husqvarna DS900 Manuel D'utilisation page 11

1. Loosen the 2 hex screws and the 2 stop screws for
the 2 guide wheels.
2. Turn the roller shafts until the guide wheels are
against the drill column.
1324 - 001 - 11.10.2019
3. Keep the position of the guide wheel and tighten the
lock screws.
Note: After you have tightened the roller shafts, they
must be possible to turn with the feed lever but not
by hand.
4. Use the feed lever to move the drill motor carriage
up and down. Make sure that the drill motor carriage
moves smoothly on the drill column. The roller shafts
must rotate and not move. If it is necessary, adjust
the roller shafts again.
11