RIKTA ESMIL Mode D'emploi page 37

RIKTA – ESMIL (2A)
® ®
II.
Set the device aperture [10] to the specified
zone of treatment.
III.
Press the
Short double beep will sound:
treatment impact on the zone begins.
During the treatment procedure, time LED
indicators [4] will blink and indicate the time
remaining until the end of the exposure:
– more than 2 minutes left — «5 min» indicator blinks;
– 1–2 minutes left — «2 min» indicator blinks;
– less than 1 minute left — «1 min» indicator blinks.
From the moment of start and till the end of treatment, the buttons
and
— «TENS –» (to reduce the voltage of electrodes)
— «TENS +» (to increase the voltage of electrodes).
At the beginning of a treatment procedure, the voltage is not sup-
plied on the electrodes.
— If the Methodical manual indicates that the impact on the zone is carried
out without TENS-therapy, after the beep do not press the button
before the end of exposure.
— If the Methodical manual indicates that the impact on the zone is car-
ried out with TENS-therapy, after the beep, press the button
to start TENS-therapy. TENS indicator [7] will start to blink.
Then adjust the TENS intensity (voltage on electrodes) according to the
personal sensations of the patient by short pressing of the
and (TENS –)buttons.
To avoid unpleasant sensations and burns, increase voltage on
the electrodes gently by shortly pressing the button
Read more about TENS-therapy on page 38.
button.
will work in the mode:
37
once,
EN
(TENS+)
(TENS +).