Preparation For Operation; Device Activation - RIKTA ESMIL Mode D'emploi

34

PREPARATION FOR OPERATION

After staying at low temperature the Device shall be kept at a room
temperature in the range of +20 ± 5°С for at least 2 hours before
switching it on.

DEVICE ACTIVATION

If, after switching on the device,
only the "5 Hz" and "2 min" indi-
cators light up you can proceed
EN
directly to the treatment proce-
dure (see "Conducting the ther-
apy session", page 36).
If the Battery» indicator [6] lights red after turning on or while working with
the device, it means that the battery is discharged and that the battery
must be recharged for normal device operation (see "Battery recharging",
page 40).
Turn on the Device, press and hold the
until you hear a beep.
Conducting
the therapy
session
page 36
If the Device had been off for more than
8 hours then when the Device is turned
on all frequency indicators [1] and all
time indicators [4] will light up.
At that buttons
not respond to pressing: the Device is
standing by waiting on the serviceabil-
ity check (see "Device Serviceability
Check", page
Operating manual
button
Service-
ability
check
page 35
and
would
35
).