Fixing - hager S151-22X Guide D'installation

4.3 Fixing

Standard fixing method
1. Install the base in the desired location, then mark the position of the 2 fixing holes using a
pencil (Ref. mark
2. Drill holes using a 5 mm Ø drill bit.
3. Fix the base using appropriate pins and screw.
Fixing with flush-mounting box
1. For boxes of 60 mm diameter: use holes marked
2. For boxes of 85 mm diameter: use holes marked
3. Fix the base using suitable screws.
CAution: for passing the interconnecting
cables, remove the 2 fixing spacers and
insert them between the ceiling and the
mounting base by covering the 2 selected
fixing holes.
optional locking of the detector on the mounting base
Optional locking is designed to prevent unauthorized dismounting of the detector.
Using cutting pliers, cut the locking nipple.
CAution: opening will now be possible
only by means of a flat blade screwdriver.
or ).
60 5
Diameter 85 fixing holes
.
60
.
5
Diameter 60 fixing holes
Locking nipple
41
GB
Alignment position
in the key test
Fixing spacers