Use - Franke FKU 1008 I TC Mode D'emploi Et Installation

USE

A B
C
Button Function
A Turns the suction motor on and off at the
last speed used.
B Decreases the working speed.
C Increases the working speed.
D Activates intensive speed from any other
speed, including motor off. This speed is
timed to run for 10 minutes, after which
the system will return to the speed that
was previously set. Suitable for dealing
with severe cooking fumes.
E Starts the motor at a speed that allows a
suction of 100 m
hour, after which the motor stops.
F Activates automatic switch-off with a 30'
delay. Suitable to complete elimination of
residual odours. Can be activated from any
position, it is deactivated by pressing the
button of turning the motor off.
G Performs a Reset of the Filter saturation
alarm when the button is pressed for ap-
proximately 2 seconds.
H Turns the Lighting System on and off.
Keyboard Lock Command: it is possible to lock the keyboard, for example when cleaning the
Glass, when the Hood Motor and Lights are turned off.
Press F (Delay) for approximately 5 seconds to enable or disable Keyboard Locking, which is
always confirmed by a Beep and an animated signal on the display motor bar.
EN
D
Control panel
Display
Displays the speed set.
Decreases the lighted segments.
Increases the lighted segments.
I flashes and the segments on the Display are
all lit.
It is disabled by pressing the Button.
Displays 24 and the segments on the Display,
3
/h for 10 minutes every initially all lit, turn off one at a time in cycle.
It is disabled by pressing the Button.
Displays a flashing Clock symbol.
It is disabled by pressing the Button.
After 100 hours operation the Drop symbol is
displayed to indicate saturation of the Metal
Grease Filters.
After 200 hours operation the letter C is dis-
played to indicate saturation of the Activated
Charcoal Filters.
F
E G
H
2
24
4