Franke FKU 1008 I TC Mode D'emploi Et Installation page 26

This filter cannot be washed or regenerated. It must be replaced when the C appears on the
display or at least once every 4 months. The filter saturation alarm has to be activated already
before.
Activation of the alarm signal
• In the recycling version hoods the filter saturation alarm must be activated during the instal-
lation or later.
• Switch off the hood and the lights.
• Press the E-key for about 5 seconds until the last two segments of the motor LEDS are lit on
the display.
• By releasing the E-key the clock icon starts to flash.
• Within 3 seconds press the D-key to activate/deactivate charcoal filter saturation alarm.
• C-symbol lit - charcoal filter saturation alarm ACTIVATED.
• C-symbol unlit - charcoal filter saturation alarm DEACTIVATED.
SUBSTITUTION OF THE CHARCOAL FILTER
Alarm reset
• Switch off the motor and the lighting system.
• Press the G-key for at least 2 seconds.
Substitution of the filter
• Open the confort panel.
• Remove the metal grease filters.
• Remove the charcoal filter as indicated in the picture.
• Place the filter again into its seat.
• Place again the metal grease filters into their place.
CHANGING LAMP
16 W Neon Lamp
• Open the comfort panel.
• Remove the neon lamp guard by unfastening the screws and
sliding it out of its housing.
• Change the Neon lamp or the Starter, taking care to ensure that
the new components have the same characteristics as the old
ones.
• Replace the neon lamp guard.
• Close the comfort panel.
EN
Charcoal filter (recycling version)
Lighting
2
26
6