Installing Your Refrigerator; Unpacking Your Refrigerator - AYA ARM2001A+ Instructions D'utilisation

2 . INSTALLING YOUR REFRIGERATOR

User should take out the door handle in the plastic bag, and install it into the door.
Then take out the two handle stopples and cover the installed screws with them. The
handle stopple and screw stopple in the plastic bag can be used when the user wants
the door to be opened from left.

UNPACKING YOUR REFRIGERATOR

WARNING: Use two or more people to move refrigerator.
Failure to do so can result in back or other injury.
•Remove tape and any labels from your refrigerator before using(except the rating
label).
To remove any remaining tape or glue, rub the area briskly with your thumb.
Tape or glue residue can also be easily removed by rubbing a small amount of liquid-
dish soap over the adhesive with your fingers. Wipe with warm water and dry.
•Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners
to remove tape or glue. These products can damage the surface of your refrigerator.
•When moving the refrigerator, do not tilt the refrigerator beyond 45°from upright
position.
CLEANING BEFORE USE
After you remove all of the packaging materials, （in particular, the foam between
the outside condenser and cabinet should be taken off）clean the inside of your refriger-
ator before using it.
SPACE REQUIREMENTS
WARNING: Keep flammable materials and vapors, such as gasoline, away form refriger-
ator.Failure to do so can result in death,explosion, fine or burns.
•To ensure proper ventilation for your refrigerator, allow for 200mm space on each
side between walls, 100mm space between back of your refrigerator and the wall, and
300mm space between counter top and the roof or ceiling.
•If you are installing your refrigerator next to a fixed wall, leave sufficient space on the
hinge side to allow for the door to swing open.
•Never install your refrigerator near heat source and direct su
- 19 -
n shins.