EUROM Valencia Manuel D'utilisation page 31


You can generate maximum 10 time settings. Prevent the setting from
containing any conflicting or overlapping orders.
 To operate the stove according to the timer settings, do the following:

Switch on the stove using the ON/OFF button.

Press the 1000W or 2000W button to set the desired output. If the desired
temperature is above the ambient temperature, the stove will begin to heat.
Do not use the IC button when you use the timer! The corresponding light
will light up on the display: 1 star or 2 stars.

By pressing the 'dimmer' button (there are 5 positions), you can intensity or
decrease the flame effect of the stove.

Now activate the timer by pressing on the TIMER ON/OFF button. The
operating-timer light will light up and the timer set 01 will flash. If you press
OK now, then the heater will completely process all the settings once until
Sunday evening 24:00. If you want to repeat the set weekly schedule, press
once again on the TIMER ON/OFF button. A symbol ][ will appear on the
display. If you now press OK, the timer setting will be repeated weekly.

If you don't select a time setting, then the stove will automatically select
setting 01 after flashing approx. 14 times and the heater will completely
process all the settings once until Sunday evening 24:00.
Attention! All timer settings (maximum 10 per week) will be processed
completely one by one. Therefore, make sure that they do not contradict
each other!

If you wish, you can also readjust the thermostat, output and dimmer while
the timer is working.

You stop the operation of the timer by pressing on the TIMER ON/OFF
button. The stove will act as if there are no current timer settings and will
simply operate according to the thermostat and output settings. By pressing
the TIMER ON/OFF button again, you reactivate the timer setting.

To erase the timer setting, press on the TIMER SET button. 01 will start
flashing on the display. Using the + and - buttons, look for the setting number
that you want to erase and subsequently press on the C button (erasing the
timer setting). The timer setting will disappear immediately.
ATTENTION! If you want the stove to operate according to a timer programme,
it will not only have to remain on stand-by, but also switched on (using the
ON/OFF button). If this is not necessary, always switch off the stove using the
ON/OFF button, switch off the main switch and remove the plug from the
socket.
ATTENTION! Day and time are deleted if the electricity is cut off. This happens
not only when the plug is pulled out of the socket, but also if the main switch is
set to O (OFF). The timer settings however are stored. When the electricity is
restored and the timer settings are entered, then you need to reset the day and
hour settings immediately; otherwise the time will begin at 0.00!
31