Testing The 4 Way Lock; Fitting I.d. Disc(S) To Your Cat(S); Viewing Your Cat(S) Location; To View How Many Hours Since The Cat(S) - Pet Mate CAT MATE Elite Super Selective Mode D'emploi

4.3.4 The display will show time with the Minute symbol flashing. Press
the '+' button until the current Minutes setting is shown (i.e. 10 if
the current time is 12:10).
4.3.5 Press the 'SET' button to save the setting.
4.3.6 The display will now show the time with the Hour symbol flashing.
If you prefer to use AM/PM setting, press the '4 WAY' button and
the AM or PM icon will show.
4.3.7. Press the '+' until the correct Hour setting is shown (e.g. 12 if the
current time is 12:10).
4.3.8. Press the 'SET' button to save the setting.
4.3.9. The display will show the word 'START' and the minutes will flash.
Press the '+' button until the desired minutes setting is shown, (in
the above example '00'). Press the 'SET' button to save the setting.
4.3.10 Then set the hours in the same way (in the above example 19:00).
4.3.11 The display will show the 'FINISH' time. Set in the same way as the
'START' time. Remember to press 'SET' to save the setting.
When the Timer is set, the 'CLOCK FACE' on the display will be shown.
When the timed lock is active, the access option symbol chosen at 4.3.2 will
flash slowly. (NOTE: the display may not show the chosen lock setting for up
to 1 minute.).
To check the time settings, press the 'TIMER' button for 1 second and
release. The display will show the timed access option selected and the
'START' time. Press the 'TIMER' button again to show 'FINISH' time. The
display will revert to current time after 20 seconds.
To cancel timer control and revert back to the normal access option:
4.3.12 Press the 'TIMER' button for 5 seconds.
4.3.13 Press the '4 WAY' button and go back through the options until you
come to 'OFF'.
4.3.14 Press the 'SET' button to save the setting.
(NOTE: the display may not show the chosen lock setting for up to
1 minute.).

5. Testing the 4 Way Lock

To operate the cat flap, you must push the flap and have a programmed I.D.
Disc.
The cat flap will look for an I.D. Disc for 2-6 seconds. (The I.D. Disc search
indicator flashes to confirm this). If the I.D. Disc is programmed to allow
your cat access, the flap will be unlocked.
8
To test the cat flap:
5.1 Set the '4 WAY' lock as 'IN & OUT' (See section 4.1).
5.2 Place the programmed I.D. Disc in front of the cat flap door as shown
in Fig. 5 and PUSH the flap. The flap should then unlock.
5.3 Fully open the flap and allow it to close. You will hear it re-lock.
If you repeatedly press the flap without an I.D. Disc being close to the flap,
it will go into 'POWER SAVING' mode. You should wait 60 seconds before
trying again.
(NOTE: Once the flap has been opened, the 'POWER SAVING' mode is
cancelled).

6. Fitting I.D. Disc(s) to your Cat(s)

6.1 If desired, record your cat's details on the I.D. label by writing on the
label in pen and sticking the clear waterproof cover over the writing.
6.2 IMPORTANT: Attach the Disc directly to the collar, NOT from a ring
attached to the collar) so that it is as high as possible and parallel to
flap (as shown in Fig. 7).
We recommend the use of a fabric collar without large metal attachments,
(other name discs etc.).

7. Viewing Your Cat(s) Location

The LCD shows at a glance, the location of up to three cats (1-3).
The cat last went through the flap, coming into the house;
The cat last went through the flap, going out of the house.
Please note this display is only a guide to your cats' location. The cat flap
determines the location of your cat by recording its last movement through
the cat flap. The results may be misleading if the cat has an alternative
entrance/exit to the house or if the cat has followed another cat through the
cat flap; if it only puts its nose out of the cat flap etc.
8. To View How Many Hours Since the Cat(s) Last Used the Cat Flap
8.1 To view how many hours since cats 1, 2 or 3 last used the cat flap,
press the '+' button for 1 second.
8.2 The display will show the symbol for 'CAT 1' and how many hours ago
'CAT 1' used the flap up to a maximum of 99 hours.
8.3 Press '+' again for similar information on Cats 2 and 3.
8.4 Press '+' a fourth time (or leave for 20 seconds) and the normal display
will be resumed.
9