Contents Page
Operation Summary . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
4. Access Options . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
last used the flap . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10
or if Your Cat Has Lost its I.D. Disc . . . . . . . . . . . . . . . . . . . . . . . . 10
12. Factory Reset . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
13. Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
4
1. Introduction
Thank you for choosing the Cat Mate Elite Super Selective Cat Flap.
WE RECOMMEND THAT YOU CAREFULLY READ THESE INSTRUCTIONS TO
BECOME FAMILIAR WITH THE CAT FLAP BEFORE YOU INSTALL IT.
The Cat Mate Elite Super Selective Cat Flap allows you to control up to 8
cats' access to and from your cat flap. Furthermore, it will allow you to
monitor up to 3 individual cats' movements: showing whether your cat(s)
last entered or exited the cat flap, and how many hours since your cat(s) last
used the flap.
To ensure that your chosen settings cannot easily be tampered with, we
have made the control buttons so that they need to be pressed firmly to
operate.
Once you have started the set-up process and you wish to stop a particular
task at any stage, you can 'TIME OUT' of the system after 60 seconds.
Settings will not be saved unless you press the 'SET' button.
2. Fitting the Batteries
2.1 Remove the battery cover by pushing the battery cover upwards (see
Fig. 2). The cover will snap off.
2.2 Insert 4 x AA (R6) Alkaline batteries as shown (Fig. 3), by sliding the 2
end batteries in first.
3. Programming the I.D. Disc(s)
The next step is to program your I.D. Disc(s). Each cat (up to a maximum of
8), will need its own unique I.D. Disc. We recommend that you now choose
a number for your cat(s) and mark it on the I.D. Disc label (i.e. 1,2,3 etc.),
for future reference. There is a table at the end of these instructions to
record this information.
NOTE: the programming sequence is time sensitive and the LCD will revert
to the normal display if each step is not completed within 60 seconds.
In order for the flap to recognise your cat(s) I.D. Disc, you need to do the
following:
3.1 Press and hold the 'PROGRAM' button on the right hand end of the
circuit board for 5 seconds (Fig. 4) until the display flashes.
3.2 'CAT 1' and the 'NUMBER 1' will flash - there will be lines moving
around the first 'TWO ZEROS'.
3.3 Place the front of the I.D. Disc up against the flap (Fig. 5).
3.4 When the cat flap has programmed the I.D. Disc, the 'TWO ZEROS' will
disappear and a 'P' will flash.
5