Maintenance And Cleaning - Elem Garden Technic THE551 Traduction Des Instructions D'origine

when the tool is switched off and when it is
running idle in addition to the trigger time).
Power supply
The hedge trimmer is designed for use only with
single-phase alternating current from a 230V 50Hz
AC supply. It is totally insulated, enabling it to be
connected also to socket-outlets without a PE
conductor.
Before you use the hedge trimmer for the first
time, check that your mains voltage is the same as
the operating voltage specified on the machine's
rating plate.
Startup and operation
Caution! This hedge trimmer is designed to cut
hedges, bushes and shrubs. Any other use which is
not expressly permitted in these instructions may
cause damage to the hedge trimmer and place the
user at serious risk. Your hedge trimmer is equipped
with a two-hand safety circuit. This means that it
works only when the switch button on the guide
handle (Figure 1 / Item 3) is pressed with the one
hand while the switch on the handle (Figure 1 / Item
4) is being pressed with the other hand. If you let go
of either switching element, the blades will stop
moving.
The blades take time to slow down to a
standstill. Please make allowance.
- Check that the blades are working properly. High
cutting performance and smooth operation are
guaranteed by the counter-rotating, dual-edge
blades.
- Fasten the extension cable in the corresponding
cable holder (see Figure 4) each time before you
use the hedge trimmer.
- Use only approved extension cables for outdoor
use
Practical tips
_ The hedge trimmer can be used to cut shrubs
and bushes as well as hedges.
_ For the best performance, hold the hedge trimmer
with its teeth at an angle of approx. 15° to
the hedge (see Figure 5).
_ Cutting in both directions is possible with the
counter-rotating dual-edge blades (see Figure 6).
_ To trim your hedge to a uniform height, run a
length of string along the hedge for guidance and
cut off the projecting branches (see Figure 7).
_ Cut the sides of the hedge with sweeping
movements from the bottom up (see Figure 8).

Maintenance and cleaning

Before performing maintenance to
the machine, always unplug the
_ Switch off the hedge trimmer and pull out its
power plug before you put it down and clean it.
_ For the best cutting performance at all times,
clean and lubricate the blades ate regular intervals.
Remove deposits with a brush and apply a
thin film of oil (see Figure 9).
Use bio-degradable oils.
_ Clean the plastic housing and parts with a mild
household detergent and a damp cloth. Never
use aggressive agents or solvents.
_ Be particularly careful not to allow any water to
get inside the machine.
_ The supplied storage case can be fastened to the
wall. This is the best place to store your hedge
trimmer.
Troubleshooting
The machine does not work: Check that the power
cable is connected properly and check the mains
fuses. If the machine will not work in spite of the
voltage supply being OK, please send it to the
specified after-sales service address.
Disposal
Important!
The hedge trimmer and its accessories are made of
an assortment of materials, e.g. metal and plastics.
Defective components must be disposed of as
special waste. Do not throw in the household refuse
bin!
Ask your dealer or local authority.
GUARANTEE
Refer to the enclosed guarantee conditions
for the terms and conditions of guarantee.
DISPOSAL
Should your machine need
replacement after extended use,
do not put it in the domestic
waste but dispose of it in an
environmentally safe way.
machine.
20