Sony WEGA KP-FX432 Mode D'emploi page 7

Step 2
Connect the antenna
If you wish to connect a VCR, see the "Connect a VCR" diagram on page 8.
Antenna cable (not supplied)
or
Antenna cable (not supplied)
: Signal flow
For optimum Performance
To connect the projection TV to the antenna or the VCR, use an
antenna cable (not supplied).
Note that one end of the cable has a male plug fitted while the other
end is fitted with a female socket. Connect the male plug to the 8
(antenna) terminal of the projection TV.
CAUTION
Do not connect the power cord until all other connections are complete;
otherwise, a minimal current leakage through the antenna or other terminals
to the ground could occur.
Rear of projection TV
Using Your New Projection TV
continued
7