Additional Information; Troubleshooting - Sony WEGA KP-FX432 Mode D'emploi

Additional Information

Troubleshooting

If you have any problem while viewing your projection TV, please check the following
troubleshooting guide. If the problem persists, contact your Sony dealer.
Symptom
• The connection is
Snowy picture
loose or the cable is
damaged.
• Channel presetting
is inappropriate or
incomplete.
Noisy sound
• The antenna type is
inappropriate.
• The antenna
direction needs
adjustment.
• Signal transmission
is low.
• Broadcast signals
Distorted picture
are too strong.
Noisy sound
Good picture • The TV system
setting is
inappropriate.
Noisy sound
• The sound of the
right picture is
selected when
TWIN pictures are
displayed.
Possible cause
• Check the antenna cable and
• Display the "Channel Setup" menu
• Check the antenna type (VHF/UHF).
• Adjust the antenna direction. Contact
• Try using a booster.
• Display the "Channel Setup" menu
• Turn off or disconnect the booster if it
• If the sound of all the channels are
• If the sound of some channels is noisy,
• Press
Solutions
connection on the projection TV, VCR
and on the wall.
under the "Setup" menu and select
"Manual Program" to preset the
channel again.
Contact a Sony dealer for advice.
a Sony dealer for advice.
under the "Setup" menu and select
"Manual Program".
Then, select " Sensitivity: Low".
is in use.
noisy, display the "Channel Setup"
menu under the "Setup"menu and
select "Auto Program" to preset the
channels again.
select the channel, then display the
"Channel Setup" menu under the
"Setup"menu and select the
appropriate TV system ("TV System").
or .
Page
7
49
–
–
–
50
–
46
49
22
continued
Additional Information
57