U Nderwater Lights - BWT P-PSC Notice D'installation Et Conseils D'utilisation

2 - WATER RETURN AND
VACUUM POINT
- Using a hole saw, code
30309010, create a hole
in the panel at the desired
position.
- From the front surface, fix the
return fitting into the panel.
Screw and tighten the nut
behind the panel.
3 - UNDERWATER LIGHTS - Uni-directional
- From the front of the panel (the inner pool side) fix the niche into the cutout. The screw housings
fit into the 12 mm pre-drilled holes. Insert a self tapping countersunk screw in each of the 4 small
notches provided and, using washers, tighten to secure the niche in position.
Liner
Lamp
PISCINES P-PSC
i
nsTalling reTurn fiTTings and Vaccum PoinT
Liner
i
nsTalling THe underwaTer ligHT
Screw Flange
Gaskets
Flange
Screws
Seals Prefix screw
2020/05 - Indice de révision : B - Code : 37101
Nut
41/48