Assembling The Walls - BWT P-PSC Notice D'installation Et Conseils D'utilisation

5.

ASSEMBLING THE WALLS

It is always best to have a level surface, however, unless the concrete underslab has already been
poured, the bottom of most excavations will not be perfectly flat.
The quick positioning PPP supporting braces get around this inconvenience and remove the need
for jacks or other levelling systems.
- CORNER PANELS AND SUPPORTING BRACES:
After completing the excavation and preparing the bottom of the excavation, position the PPP
panels and corner panels in the hole, leaning them against the sides of the excavation (smooth
side facing out).
Ensure that you have the correct number of panels and that the panels featuring cut-outs for the
skimmer, water suction and water return fittings and the underwater lights, if any, are correctly
positioned. Ensure that the cut-out is oriented upwards.
AS FAR AS POSSIBLE POSITION PANELS OF
SIMILAR DIMENSIONS OPPOSITE EACH
Place the supporting braces all around the pool
perimeter close to the panel flanges. These will be
used to join the panels together.
No nuts or bolts are required; the correct number of
self-locking keys and positioning pins are moulded with
each supporting brace and may be easily detached
one by one as they are needed.
Depending on the pool wall height selected, 2 pins and 4, 5, or 6 keys will be needed to join 2
panels, or one panel and a corner panel, together with a supporting brace. The only tool required
for assembly is a mallet.
Standing in the work space between the panels and the edge of the excavation, bring together 2
panels, lining up the square apertures in the panel flanges.
Start with the corners. Hold a supporting brace perpendicular to the right hand panel with the
centring pins opposite the apertures, push them through from right to left until the holes into which
the keys will be inserted are far enough from the inner surface of the flange on the left hand panel.
Position the keys so that their vertical edge is parallel to the panel flange and lock the assembly
together using the mallet.
Check that the upper edges of the panels are thus automatically aligned.
Continue systematically in the same way for all P-PSC panels and corner panels checking that
these are correctly aligned with the pool perimeter marked out by string tied around the stakes
planted in the corners A.B.C.D. or marked in blue on the underslab once this had dried
PISCINES P-PSC
cauTion
OTHER.
2020/05 - Indice de révision : B - Code : 37101
37/48