BWT P-PSC Notice D'installation Et Conseils D'utilisation page 38

CHECK THE BASE RECTANGLE BY MEASURING THE LENGTH OF THE 2 DIAGONALS:
THESE SHOULD BE EQUAL.
Each supporting brace (height 1.25 m and1.50 m
only), comes with 2 moulded synthetic resin stakes
and a positioning pin.
Place the stakes over the apertures provided for
this purpose in the supporting brace.
Check one last time that the corresponding P-PSC
panel is correctly aligned along the pool perimeter
and drive the first stake (that closest to the panel)
into the ground using a hammer. Drive in the second
1.00 m supporting braces are fastened to the ground by a 10 x 10 belt of steel reinforcement bars
or 'rebars' onto which concrete is poured. Cut the steel belt to pass it through the supporting brace
and reattach by tying with steel reinforcement bars
1 - P-PSC panel
2 - P-PSC corner
3 - Supporting brace
4 - Adjustable stakes (1.25 m and 1.50 m) 9 - Upper edge of the panel
5 - Positioning pins
38/48
2020/05 - Indice de révision : B - Code : 37101
stake.
Stakes secure the pool wall to the ground, they
may also be used to level the upper edges of the
panels and correct their vertical position.
To do this, simply slide the supporting brace along
the rear stake and push in the positioning pin when
the desired position is attained.
Continue around the pool using a spirit level to
ensure that the panels are vertical and that the
upper edges are horizontal at each supporting
brace.
6 - Locking key
7 - Liner lock profile
8 - Self tapping screws or rivets (not provided)
PANEL ASSEMBLY
DETAIL
PISCINES P-PSC